Heated Floors

Redeemed Contracting

Heated Floors in Uniontown, OH, Installed While the Floor Is Open

Get Started

Start With a Free Discovery Call

Fifteen to thirty minutes on the phone, ending with a ballpark investment range for your project.

Fields marked with an asterisk are required.

We respond within one hour during business hours.

A heated floor is the upgrade people mention every winter afterwards, and the one they most often wish they had decided on earlier.

It only makes sense to install while the floor is already open, which means it is a decision to make at the start of a bathroom project rather than at the end.

Why the timing is the whole decision

The heat goes under the tile, as part of the assembly that includes the waterproofing. It is not a mat laid on a finished floor and it is not something added later without taking the floor back up.

So the real cost of a heated floor is not the system. It is whether the floor is open anyway. Inside a bathroom remodel it is an incremental addition. As a standalone project a year later, you are paying to demolish and rebuild a floor you already paid for once.

If you are remodeling the bathroom and you have ever thought about it, decide now.

What it is actually like

The floor is warm underfoot rather than hot, and it takes the edge off a tile floor in an Ohio winter, which is the whole point. Tile is the coldest thing most people stand on in their own house between November and March.

It runs on a thermostat, usually on a schedule, so it is warm when the room gets used and off when it does not.

It is not a heating system for the house. It is comfort in one room, and it is the single most commented-on thing in the bathrooms we have put it in.

Where it goes

Bathrooms, most often, and that is where it earns the most because it is where bare feet meet tile.

Also kitchens, entryways and any tiled floor over an unheated space. A tiled floor over a crawl space or an unconditioned basement is always the coldest one in the house.

It goes under tile as part of the waterproofing assembly. It is not put under LVP or under a surround.

Electric, not hydronic

There are two different technologies people mean when they say radiant floor heat, and they are not interchangeable. Hydronic systems run hot water through tubing connected to a boiler, and they usually heat an entire house, installed during new construction or a full mechanical overhaul. Electric systems run a thin heating cable or mat under the tile in a single room, tied into their own circuit, with no boiler and no whole-house plumbing involved.

What we build is electric. It is the right system for a single bathroom or kitchen inside a remodel, it does not touch your home's heating system, and it does not require the kind of mechanical work a hydronic system does. If somebody is quoting you a boiler-based system for a bathroom floor, ask why, because it is the wrong tool for a one-room job.

Cable or mat, and why it matters which

The heating element comes two ways. A mat is the wire pre-spaced and attached to a mesh backing, rolled out like a rug and set in mortar. It goes down fast, which makes it the right choice for a rectangular room where the shape matches the mat.

Loose cable is the same wire without the mesh, hand-spaced and clipped to the floor in whatever pattern the room actually needs. It takes longer to install, and it is the right call in a room with an odd angle, a jog around a vanity, or a footprint a standard mat was never cut for.

We use whichever one the room calls for. Most bathrooms take a mat. A bathroom with an unusual layout usually takes cable.

How it is actually built

The system goes in as part of the floor assembly.

Cable or mat, set in mortar, under the tile and above the waterproofing. It is not a layer added on top of a finished floor and it is not something a homeowner retrofits.

The thermostat is the part you interact with.

It runs on a schedule, so the floor is warm when the bathroom gets used in the morning and off the rest of the day. It is not left running.

The floor build-up rises slightly.

Usually a small amount, and it matters at doorways and where the bathroom meets an adjoining floor. It is a transition detail we plan for rather than discover, which is another reason it belongs in the design rather than added late.

Because it is inside the assembly, it is also inside our one year craftsmanship warranty. If something we installed fails within the year, we come back and correct it at no labor cost.

What you need to know before you say yes

It needs its own electrical circuit.

The system runs off a dedicated circuit back to the panel, wired by a licensed electrician while the walls are open. In an older Stark County home with a full panel, that is worth knowing at the start rather than at rough-in, because occasionally it means a panel conversation nobody planned for.

The thermostat is programmable and that is the point.

Set it to come on before the bathroom gets used in the morning and go off when the house empties. A floor that runs all day costs money for nobody's benefit, and a floor with no schedule is one somebody turns off in February and never turns back on.

It takes a while to come up to temperature.

This is not a switch that gives you a warm floor in two minutes. It is closer to a slow oven, which is exactly why the schedule matters more than the thermostat dial.

It costs less to run than people expect.

A typical bathroom-sized system, run a few hours a day through an Ohio winter, runs somewhere in the range of ten to twenty dollars a month at typical Midwest electricity rates. It is a comfort upgrade, not a line item that changes your utility bill in any way you will notice.

None of that is a reason not to do it. All four are reasons to decide before the electrician has finished rather than after.

What it costs

Heated floors are priced inside the room they go in, because the cost depends on the area and on the floor build-up that is happening anyway.

For context, a heated floor is an addition inside a bathroom project rather than a separate one. In a bathroom-sized area it is a meaningfully smaller line than the tile above it.

The discovery call gives you the range for your bathroom with and without it, so you can decide with a real number.

If a heated floor is part of a larger tile project, our tile work covers the waterproofing and installation it sits inside of.

Everything Redeemed Contracting builds is on the services page.

Why Homeowners Choose Us

The Remodeling Experience You've Been Looking For

We built our entire process around the things homeowners told us they were missing from other contractors. Communication, respect, and a crew that shows up when they say they will.

Clear Communication

We send updates, answer calls, and keep you informed, so you're never left wondering what's happening in your home.

Your Home Is Protected

We use floor protection and dust barriers and treat every surface as if it were our own.

Spotless Jobsites

We clean up every day before leaving. You'll never come home to a messy, disrespected space.

Custom to Your Home

No cookie-cutter remodels. Every decision is made specifically for your space, your style, and your goals.

A Premium Process

From first walkthrough to final handshake, the experience is structured, professional, and built around your peace of mind.

How It Works

How it gets added to your project

A structured, transparent process so you know exactly what happens, and when, from the first conversation to the final walkthrough.

01

Discovery call

You tell us the room and whether a heated floor is something you have been considering. It gets factored into the range from the start rather than added as a surprise later.

02

Design and layout

We measure the room and decide mat or cable based on the actual shape, work out where the thermostat and its sensor go, and confirm the floor build-up at every transition and doorway.

03

Electrical rough-in

A licensed electrician runs the dedicated circuit back to the panel while the walls are open. This happens alongside the rest of the bathroom's electrical work, not as a separate visit.

04

Set in the floor assembly

The heating element goes down in mortar, above the waterproofing and below the tile, exactly where it lives for the life of the floor.

05

Test and program the thermostat

Before the tile is finished, the system is tested. Once it is, we set the schedule with you so the floor is warm when you actually use the room.

Common Questions

Heated Floors FAQ

Homeowners often come to us with the same questions. Here are straightforward answers.

Have a question not listed here? We're happy to talk through any concerns before you commit to anything.

From Our Clients

What Homeowners Say About Our Work

"Joe and his team greatly deserve this 5-star review. I wish I could give more stars to be honest. Great communication, craftsmenship, and value. Top notch profesional contractor in Northeast Ohio!"

Russ Preisse

"Reasonable price Joe does what he says he's going to do and shows up when he says he's going to show up. A rare commodity these days! Quality of the work is excellent and if there's something that you're not satisfied with, he will address it immediately. Very honest and upfront."

Marianne Turner

"Joe is amazing to work with. Really honest and quality craftsmanship!"

Michael White

Get Started

Thinking About a Heated Floor?

If your bathroom project is already happening, this is the moment to decide. Start with a free 15 to 30 minute discovery call.

Part of our bathroom remodeling work.

Free Discovery Call  ·  Response Within One Hour  ·  Serving Stark County